Release : 1.1f 124 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.84 show flow-control
This command displays the flow-control information.
show flow-control [ interface <interface-type> <interface-id>]
Syntax Description
interface-type - Can be gigabit Ethernet (gi) or extreme Ethernet (ex)
or qx-ethernet (qx)
interface-id - Physical interface ID including slot and port number
Mode
Privileged EXEC Mode
Example
SMIS# show flow-control interface gigabitethernet 0/2
Port Tx FlowControl Rx FlowControl Tx Pause RxPause
---- -------------- --------------- -------- --------
Gi0/2 off off 0 0
If this command is executed without the optional parameter it displays the flow control information
of the SMIS router. Otherwise it displays the flow control information of the specified interface.
Related Commands
show interfaces - Displays interface status and configuration
flowcontrol - Enables flowcontrol on an interface
To Next Page
Loading...
