Release : 1.1f 719 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.14 neighbor - send-community
This command enables advertisement of community attributes to (standard/extended) peer and
the no form of the command disables advertisement of community attributes to
standard/extended) peer.
neighbor <ip-address> send-community {both | standard | extended}
no neighbor <ip-address> send-community {both | standard |extended}
Syntax Description
ip-address - Peer IP address
send-community - Sends Communities.
both - Send both communities and extended communities to peer
standard - Send only communities to the peer
extended - Send only extended communities to peer
Mode
Router Configuration Mode
Example
SMIS(config-router)# neighbor 23.45.0.1 send-community both
Peer must be created and peer AS must be configured.
BGP Speaker Local AS number must be configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp community – Displays the contents of community route/peer/policy/ filter tables
To Next Page
Loading...
