Supermicro SSE-G48-TG4 - Snmp-Server Trap Udp-Port

Release : 1.1f 460 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
17.11 snmp-server trap udp-port
This command configures UDP port number to be used to send SNMP traps.
The no form of this command resets the UDP port number to the default value 162.
snmp-server trap udp-port <port>
no snmp-server trap udp-port
Mode
Global Configuration Mode
Defaults
UDP port 162
Example
SMIS(config)# snmp-server trap udp-port 165
Related Commands
show snmp-server traps - Displays the SNMP server trap configuration details