Supermicro SSE-G48-TG4 - CLI Command Modes

Release : 1.1f 25 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
CLI commands need not be fully typed. The abbreviated forms of CLI commands are also
accepted by the SMIS CLI. For example, commands like "show ip global config" can be
typed as "sh ip gl co".
CLI commands are case insensitive.
CLI commands will be successful only if the dependencies are satisfied for a particular
command that is issued. Appropriate error messages will be displayed, if the
dependencies are not satisfied
2.1 CLI Command Modes
Command Mode Access Method Prompt Exit method
User EXEC This is the initial mode
to start a session.
s
mis
>
The logout method is
used.
Privileged EXEC The User EXEC mode
command enable, is
used to enter the
Privileged EXEC
mode.
S
MIS#
To return from the
Privileged EXEC
mode to User EXEC
mode the disable
command is used.
Global Configuration The Privileged EXEC
mode command
configure
terminal, is used to
enter the Global
Configuration mode
S
MIS(
c
onfig)#
To exit to the Global
Configuration mode
the exit command
is used and to exit to
the Privileged EXEC
mode the end
command is used.
Interface configuration The Global
Configuration mode
command
interface
<interfacetype><
interfaceid> is
used to enter the
Interface configuration
mode
S
MIS(
c
onfig
-
i
f)#
To exit to the Global
Configuration mode
the exit command
is used and to exit to
the Privileged EXEC
mode the end
command is used.
Config-VLAN The global
configuration mode
command vlan
vlan-id, is used to
enter the Config-
VLAN mode.
S
MIS(
c
onfig
-
vlan)#
To exit to the Global
Configuration mode
the exit command
is used and to exit to
the privileged EXEC
mode the end
command is used.
Line Configuration The global
configuration mode
command line is
used to enter the Line
S
MIS(
c
onfig
-
line)#
To exit to the Global
Configuration mode
the exit command
is used and to exit to