Release : 1.1f 714 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.9 neighbor - ebgp-multihop
This command enables BGP to establish connection with external peers that are not directly
connected and the no form of the command resets the peer EBGP-Multihop status to default. By
default, EBGP Multihop is disabled.
neighbor <ip-address> ebgp-multihop
no neighbor <ip-address> ebgp-multihop
Syntax Description
ip-address - Peer’s Remote IP address
Mode
Router Configuration Mode
Defaults
Disable
Example
SMIS(config-router)# neighbor 23.45.0.1 ebgp-multihop
By default external BGP peers need to be directly connected. If external BGP peer are not
connected directly, then ebgp-multihop is enabled to initiate the connection with that external
peer. If ebgp-multihop is disabled and external BGP peers are indirectly connection, then BGP
peer session will not be established BGP Speaker Local AS number must be configured
Peer must have been created and peer AS must be configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
To Next Page
Loading...
