Release : 1.1f 855 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.24 ipv6 ospf area
This command enables OSPFv3 for IPv6 on an interface. The no form of the command disables
OSPFv3 routing protocol on the interface.
ipv6 ospf area <IPv4-Address>
no ipv6 ospf
Syntax Description
IPv4-Address - A 32-bit integer
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# ipv6 ospf area 0.0.0.0
The no form of the command disables an interface and triggers flushing of selforiginated Link
Scope LSAs, and deletes the Link Scope LSAs associated with this interface from the Link State
Database. If there is a single interface in the associated area, then this command deletes its Area
Scope LSAs from the Link State Database.
Related Commands
show ipv6 ospf - General Information – Displays general information about the
OSPFv3 routing process
show ipv6 ospf interface – Displays the OSPFv3-related interface information
To Next Page
Loading...
