Release : 1.1f 341 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
15.5 set port gvrp
This command enables or disables GVRP on the interface.
set port gvrp <interface-type> <interface-id> { enable | disable }
Syntax Description
interface-type - Interface type
interface-id - Interface Id
enable - Enables GVRP on the interface
disable - Disables GVRP on the interface
Mode
Global Configuration Mode
Defaults
enable
Example
SMIS(config)# set port gvrp gigabitethernet 0/1 disable
The value enable indicates that GVRP is enabled on the current port, as long as global
GVRP status is also enabled for the device.
If port GVRP state is disabled, but global GVRP status is still enabled, then GVRP is
disabled on current port. Any GVRP packet received will be discarded and no GVRP
registrations will be propagated from other ports
Related Command
show vlan port config - Displays the vlan related parameters specific for ports
To Next Page
Loading...
