Supermicro SSE-G48-TG4 - Ip Rip Receive Version

Release : 1.1f 638 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
25.16 ip rip receive version
This command sets IP RIP version number for receiving advertisements and the no form of the
command sets IP RIP receive version number to its default value.
ip rip receive version { 1 | 2 | 1 2 | none }
no ip rip receive version
Syntax Description
1 | 2 | 1 2 | none - Indicates which version of RIP updates, are to be accepted
Mode
Interface Configuration Mode
Defaults
1 2
Example
SMIS(config-if)# ip rip receive version 1
The command indicates which version of RIP updates are to be accepted. rip2 and rip1 2 implies
reception of multicast packets.
Related Commands
ip rip send version– Sets IP RIP version number for transmitting advertisements
show ip rip – Displays IP RIP protocol database or statistics