Release : 1.1f 674 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.23 ip ospf retransmit-interval
This command specifies the time between link-state advertisement (LSA) retransmissions for
adjacencies belonging to the interface and the no form of the command uses the default time
between link-state advertisement (LSA) retransmissions for adjacencies belonging to the
interface.
ip ospf retransmit-interval <seconds (0 - 3600)>
no ip ospf retransmit-interval
Mode
Interface Configuration Mode
Defaults
5
Example
SMIS(config-if)# ip ospf retransmit-interval 300
This value is also used while retransmitting database description and link-state request packets.
Related Commands
ip ospf hello-interval – Specifies the interval between hello packets sent on the
interface
ip ospf dead-interval – Sets the interval at which hello packets must not be seen before
neighbors declare the router down
ip ospf transmit-delay – Sets the estimated time it takes to transmit a link state update
packet on the interface
show ip ospf retransmission-list – Displays OSPF Link state retransmission list
information
To Next Page
Loading...
