Supermicro SSE-G48-TG4 - Show System Information

Release : 1.1f 137 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.97 show system information
This command displays system information.
show system information
Mode
Privileged EXEC Mode
Example
SMIS# show system information
Switch Name : SMIS
Switch Base MAC Address : 00:30:48:90:00:e2
Default IP Address : 10.0.0.1
Default Subnet Mask : 255.0.0.0
Default IP Address Config Mode : Manual
Default IP Address Allocation Protocol : DHCP
SNMP EngineID : 80.00.08.1c.04.46.53
System Contact : support@supermicro.com
System Location : SUPERMICRO
Logging Option : Console Logging
Login Authentication Mode : Local
PIM Mode : Dense Mode
Snoop Forward Mode : MAC based
Config Restore Status : Successful
Config Restore Option : Restore
Config Restore Filename : iss1.conf
Config Save IP Address : 0.0.0.0
NTP Broadcast Mode : No
Related Commands
write - Writes the running-config to a file in flash, startup-configuration file or to a remote site
erase- Clears the contents of the startup configuration or sets parameters in NVRAM to default
values