Release : 1.1f 546 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.12 rp-candidate holdtime
This command sets the holdtime of the component when it is a candidate RP in the local domain
and the no form of the command sets the default holdtime (0) of the component.
rp-candidate holdtime <Holdtime value (0-255)>
no rp-candidate holdtime
Mode
PIM Component Mode
Defaults
0
Example
SMIS(pim-comp)# rp-candidate holdtime 25
If its value is set to 0, it indicates that the local system is not a candidate RP Holdtime is
the amount of time the candidate RP advertisement is valid. This field allows
advertisements to be aged out.
Related Command
show ip pim rp-candidate – Displays the RP-candidate information
To Next Page
Loading...
