Supermicro SSE-G48-TG4 - Ipv6 Nd Other-Config Flag

Release : 1.1f 783 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
28.9 ipv6 nd other-config flag
This command sets the 'other config flag' which allows the host to use DHCP for other stateful
configuration. The no form of the command resets the 'other config flag' which in turn does not
allow the host to use DHCP for other stateful configuration.
ipv6 nd other-config flag
no ipv6 nd other-config flag
Mode
Interface Configuration Mode
Example
SMIS(config-if)# ipv6 nd other-config flag
Related Command
no ipv6 nd suppress-ra – Enables IPv6 router advertisement