Release : 1.1f 366 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
15.28 vlan map-priority
This command maps a priority to a traffic class on the specified port. The frame received on the
interface with the configured priority will be processed in the configured traffic class..
The no form of the command maps the default priority to traffic class value on the port.
vlan map-priority <priority value(0-7)> traffic-class <Traffic class
value(0-7)>
no vlan map-priority <priority value (0-7)>
Syntax Description
traffic-class - Traffic class value
Mode
Interface Configuration Mode
Example
SMIS(config-if)# vlan map-priority 2 traffic-class 2
The default traffic class value depends upon the configured priority value.
Following is the list of default traffic class values for different priority values
Priority Default traffic class
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Related Command
show vlan traffic-classes - Displays the traffic classes information of all the available
interfaces
To Next Page
Loading...
