Release : 1.1f 561 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.26 show ip pim neighbor
This command displays the router's PIM neighbors’ information.
show ip pim neighbor [ Vlan <vlan-id> | <iftype> <ifnum>]
Syntax Description
Vlan - VLAN ID
iftype - Interface type, can either be a gi, ex or qx ethernet interfaces
ifnum - Physical interface ID including slot and port number
Mode
Privileged EXEC Mode
Example
SMIS# show ip pim neighbor vlan 1
Nbr IfName/Idx Uptime/Expiry Ver DRPri/Mode
CompId Override Lan
Address Interval Delay
------------- ------------- --- ---------- ------ -------- ------
10.0.0.1 vlan1/160 00:03:41/92 v2 32/S 20 0 0
10.0.0.2 vlan1/160 00:04:13/97 v2 32/S 20 0 0
It shows the Neighbor Address, the interface used to reach the PIM Neighbor, the Up
time (the time since this neighbor became the neighbor of the local router), Expiry Time
(the min. time remaining before this PIM neighbor will be aged out), LAN delay and
Override interval.
Related Commands
ip pim query-interval – Sets the frequency at which PIM hello messages are transmitted
on this interface
ip pim message-interval – Sets the frequency at which PIM Join/Prune messages are
transmitted on this PIM interface
ip pim bsr-candidate – Sets the preference value for the local interface as a candidate
bootstrap router
ip pim hello-holdtime – Sets the holdtime for the hello message for that interface
To Next Page
Loading...
