Release : 1.1f 560 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
Sparse
PIM DR: 10.0.0.1
PIM DR Priority: 5
PIM Neighbour Count: 0
PIM Hello/Query Interval: 45
PIM Message Interval: 67
PIM Override Interval: 56
PIM Lan Delay: 66
PIM Lan-Prune-Delay: Disabled
PIM Component Id: 1
PIM domain border: disabled
It shows the list of Interface addresses, the mode of the interface, Designated Router on that
interface, Hello Interval, Join/Prune Interval of the interface.
Related Commands
set ip pim – Enables or disables PIM
ip pim query-interval – Sets the frequency at which PIM hello messages are transmitted
on this interface
ip pim message-interval – Sets the frequency at which PIM Join/Prune messages are
transmitted on this PIM interface
ip pim bsr-candidate – Sets the preference value for the local interface as a candidate
bootstrap router
ip pim hello-holdtime – Sets the holdtime for the hello message for that interface
ip pim dr-priority – Sets the designated router priority value configured for the router
interface
ip pim override-interval – Sets the override interval configured for router interface
ip pim lan-delay – Sets the LanDelay configured for the router interface
set ip pim lan-prune-delay – Sets the LanPruneDelay bit configured for the router
interface to advertise the lan delay
no ip pim interface – Deletes an interface at PIM level
debug ip pim – Enables PIM trace
To Next Page
Loading...
