Release : 1.1f 860 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.29 ipv6 ospf hello-interval
This command specifies the time interval between the OSPFv3 hello packets on a particular
interface (the length of time, in seconds, between the Hello packets that the router sends on the
interface). The no form of the command sets the default hello interval for an interface.
ipv6 ospf hello-interval <1-65535>
no ipv6 ospf hello-interval
Mode
Interface Configuration Mode
Defaults
interval - 10
Example
SMIS(config-if)# ipv6 ospf hello-interval 20
The hello interval value must be same for all routers attached to a common link.
Related Command
show ipv6 ospf interface – Displays the OSPFv3-related interface information
To Next Page
Loading...
