Release : 1.1f 708 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.3 ip bgp overlap-policy
This command configures the Overlap Route policy for the BGP Speaker. The no form of the
command. Resets the Overlap route policy to default. By default, both less and more specific
routes are installed.
ip bgp overlap-policy <more-specific|less-specific|both>
no ip bgp overlap-policy
Syntax Description
more-specific - This installs only more-specific routes in the RIB
less-specific - This installs only less-specific routes in the RIB
both - This installs all routes(more-specific and less-specific) in the RIB
Mode
Global Configuration Mode
Defaults
Both
Example
SMIS(config)# ip bgp overlap-policy more-specific
BGP Speaker Local AS number must be configured.
BGP Speaker Admin Status must be DOWN
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
shutdown ip bgp – Sets the BGP Speaker Global Admin status DOWN
show ip bgp summary – Displays the status of all BGP4 connections
To Next Page
Loading...
