Supermicro SSE-G48-TG4 - Ip Igmp Snooping Group-Query-Interval

Release : 1.1f 309 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
14.8 ip igmp snooping group-query-interval
This command sets the time interval after which the switch sends a group specific query on a
port. The no form of the commands sets the group specific query interval time to default value.
ip igmp snooping group-query-interval <2-5) seconds>
no ip igmp snooping group-query-interval
Mode
Global Configuration Mode
Defaults
2
Example
SMIS(config)# ip igmp snooping group-query-interval 3
Related Commands
show ip igmp snooping globals - Displays the IGMP snooping information for all VLANs
or a specific VLAN
show ip igmp snooping statistics - Displays IGMP snooping statistics for all VLANs or
a specific VLAN
show ip igmp snooping groups - Displays IGMP group information for all VLANs or a
specific VLAN