Supermicro SSE-G48-TG4 - Set Ip Pim Regstop-Ratelimit-Period

Release : 1.1f 540 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.6 set ip pim regstop-ratelimit-period
This command specifies the period over which RP monitors the number of register packets after
sending the register stop message.
set ip pim regstop-ratelimit-period <0-2147483647(in secs)>
Mode
Global Configuration Mode
Defaults
5
Example
iss (config)# set ip pim regstop-ratelimit-period 100
Register stop message is used to avoid encapsulation of multicast data packets from the
first hop router to the RP.
Related Command
show ip pim thresholds – Displays threshold configured for SPT, RP thresholds, rate limit
values for both SM