Release : 1.1f 706 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.2 ip bgp dampening
This command Configures the Dampening Parameters and the no form of the command resets
the Dampening Parameters to default.
ip bgp dampening [<HalfLife-Time> [<Reuse Value> [<Suppress Value>
[<Max-Suppress Time>]]]] [-s <Decay Granularity> [<Reuse Granularity>
[<Reuse Array Size>]]]
no ip bgp dampening [HalfLife-Time [Reuse-Value [Suppress-Value [Max-
Suppress-Time]]]] [-s [Decay-Granularity [Reuse-Granularity [Reuse-
Array-Size]]]
Syntax Description
HalfLife-Time - Time (in seconds) after which a penalty is decreased by half. Once a route
has been assigned a penalty, the penalty is decreased by half after the half-life time
Reuse Value - If the penalty associated with a suppressed route falls below this value, the
route is re-used
Suppress Value - A route is suppressed when the penalty associated with the route exceeds
this value
Max-Suppress Time - Maximum time (in seconds) a route can be suppressed
Decay Granularity - Time granularity in seconds used to perform all decay computations
Reuse Granularity - Time interval between evaluations of the reuse-lists. Each reuse lists
corresponds to an additional time increment
Reuse Array Size - Size of reuse index arrays. This size determines the accuracy with which
suppressed routes can be placed within the set of reuse lists when suppressed for a long time
Mode
Global Configuration Mode
Defaults
HalfLife-Time - 900
Reuse Value - 500
Suppress Value - 3500
Max-Suppress Time - 3600
Decay Granularity - 1
Reuse Granularity - 15
Reuse Array Size - 1024
To Next Page
Loading...
