Supermicro SSE-G48-TG4 - Loop-Protect Disable-Period

Release : 1.1f 950 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
34.3 loop-protect disable-period
Switch disables (shuts down) the loop detected ports.
This command configures the disable period for which the loop detected ports are kept down.
By default disable period value is 0 which means the loop detected ports are kept down until user
enables it manually.
The no form of this command removes the configured disable period value and reset it to the
default value 0.
loop-protect disable-period <integer(0-604800)>
no loop-protect disable-period
Syntax Description
disable-period – number of seconds the loop detected ports are kept
down.
Mode
Global Configuration Mode
Defaults
disable
Example
SMIS(config)# loop-protect disable-period 30
Related Commands
show loop-protect – Displays the loop protection disable period information.