Release : 1.1f 431 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.11 netbios-name-server
This command sets the NetBIOS (WINS) name servers in the DHCP server configuration
parameters.
The no form of the command deletes the NetBIOS name server from the DHCP configuration
parameters.
netbios-name-server <ip address>
no netbios-name-server
Mode
DHCP Pool Configuration Mode
Example
SMIS(dhcp-config)# netbios-name-server 20.0.0.3
The configuration of this command will take effect only after configuring the network
address pool using network command.
Related Commands
service dhcp-server - Enables the DHCP server
show ip dhcp server information - Displays the server information
show ip dhcp server pools - Displays the DHCP server pools
show ip dhcp server binding - Displays the DHCP server binding information
show ip dhcp server statistics - Displays the DHCP server statistics
network - Configures the Network IP of the address pool
To Next Page
Loading...
