Release : 1.1f 723 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.18 default-metric
This command configures the Default IGP Metric value and the no form of the command resets
the Default IGP Metric value.
default-metric <Default Metric Value>
no default-metric
Mode
Router Configuration Mode
Defaults
0
Example
SMIS(config-router)# default-metric 300
This command sets the default metric to be associated with all redistributed routes. If a metric
value is not supplied, the default metric value is assigned as 0.
If the default metric value is 0, then the received route-metric is advertised. Any non-zero metric
value is used as the metric value for all the redistributed routes.
The metric of redistributed Local Routes is not affected by the default-metric value.
BGP Speaker Local AS number must be configured
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
To Next Page
Loading...
