Release : 1.1f 286 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
13.5 channel-group
This command configures an Etherchannel and the no form of the command removes an
interface from
the Etherchannel.
channel-group <channel-group-number(1-65535)> mode {active | passive |
on}
no channel-group
Syntax Description
mode - mode represents any one of the following:
active - LACP negotiation is started un-conditionally
passive - LACP negotiation is started only when LACP packet is received from peer
on - Force the interface to channel without LACP. This is equivalent to manual aggregation
Mode
Interface Configuration Mode
Example
SMIS(config-if)# channel-group 1 mode active
If the port-channel is not present then the port channel must be created.
Related Command
show etherchannel - Displays etherchannel detailed / port information
To Next Page
Loading...
