Supermicro SSE-G48-TG4 - Set Ip Dvmrp - Interface

Release : 1.1f 529 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
21.3 set ip dvmrp - interface
This command enables/disables DVMRP on the interface.
set ip dvmrp { enable | disable }
Syntax Description
enable - Enables DVMRP on the interface
disable - Disables DVMRP on the interface
Mode
Interface Configuration Mode
Defaults
disable
Example
SMIS(config-if)# set ip dvmrp enable
DVMRP must be enabled globally prior to the execution of this command.
Related Commands
set ip dvmrp – Enables / disables DVMRP in the switch
show ip dvmrp – Displays the DVMRP details