Supermicro SSE-G48-TG4 - Set Ip Pim Rp-Switchperiod

Release : 1.1f 539 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.5 set ip pim rp-switchperiod
This command specifies the period (in seconds) over which RP monitors register packets for
switching to the source specific shortest path tree.
set ip pim rp-switchperiod <0-2147483647(in secs)>
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim rp- switchperiod 100
To switch to SPT, this period must be configured RP-tree is a pattern that multicast
packets are sent to a PIM-SM router by unicast and then forwarded to actual recipients
from RP
Related Command
show ip pim thresholds – Displays threshold configured for SPT, RP thresholds, rate limit
values for both SM