Release : 1.1f 952 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
34.5 loop-protect transmit-interval
When loop protection feature is enabled, switch transmits Ethernet control frames periodically to
detect the network loops. By default Ethernet control frames are sent every 5 seconds once.
This command helps to configure the period on which the Ethernet control frames are
transmitted.
The no form of this command resets the transmit interval period to the default value 5 seconds.
loop-protect transmit-interval <integer(1-10)>
no loop-protect transmit-interval
Syntax Description
Transmit-interval – number of seconds between subsequent Ethernet control frames sent out
Mode
Global Configuration Mode
Defaults
5
Example
SMIS(config)# loop-protect transmit-interval 10
Related Commands
show loop-protect – Displays the loop protection transmit interval information.
To Next Page
Loading...
