Release : 1.1f 538 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.4 set ip pim rp-threshold
This command specifies the threshold at which the RP (Rendezvous Point) initiates switching to
source specific shortest path tree.
set ip pim rp-threshold <0-2147483647(number of reg packets)>
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim rp-threshold 50
To switch to SPT, this threshold must be configured and this switching is based on the
number of registered packets received.
Related Command
show ip pim thresholds – Displays threshold configured for SPT, RP thresholds, rate limit
values for both SM and DM
To Next Page
Loading...
