Release : 1.1f 110 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.72 rate-limit
This command configures the egress rate limiting and burst size for the physical interfaces. The
given rate and burst size values are adjusted to the closest possible value supported by the
hardware. The no form of this command disables the rate limiting on the interface.
rate-limit output <rate-value-kbps (1-10000000)> <burst-value-kbits (1-
10000000)>
no rate-limit output
Syntax Description
rate-value-kbps – Any number between 1 to 10000000 in kbps.
burst-value-kbits - Any number between 1 to 10000000 in kbits
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# rate-limit output 10000000 10000
Related Command
show interfaces - Displays the interface status and configuration
To Next Page
Loading...
