Release : 1.1f 676 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.25 ip ospf priority
This command sets the router priority and the no form of the command sets default value for
router priority.
ip ospf priority <value (0 - 255)>
no ip ospf priority
Mode
Interface Configuration Mode
Defaults
1
Example
SMIS(config-if)# ip ospf priority 25
When two routers attached to a network attempt to become the designated router, the one with
the higher router priority takes precedence. If there is a tie, the router with the higher router ID
takes precedence.
Related Commands
ip ospf network – Configures the OSPF network type to a type other than the default for a
given media
neighbor – Specifies a neighbor router and its priority
To Next Page
Loading...
