Release : 1.1f 654 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.7 neighbor
This command specifies a neighbor router and its priority. The no form of the command removes
the neighbor/Set default value for the Neighbor Priority.
neighbor <neighbor-id> [priority <priority value (0-255)>]
no neighbor <neighbor-id> [priority]
Syntax Description
neighbor-id - Neighbor router ID
priority - A number value that specifies the router priority
Mode
Router Configuration Mode
Defaults
priority - 1
Example
SMIS(config-router)# neighbor 20.0.0.1 priority 25
The value 0 signifies that the neighbor is not eligible to become the designated router on this
particular network.
Related Commands
ip ospf priority – Sets the router priority
ip ospf network – Configures the OSPF network type to a type other than the default for a
given media
show ip ospf neighbor– Displays OSPF neighbor information list
To Next Page
Loading...
