Release : 1.1f 779 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
28.5 ipv6 - static routes
This command configures static routes. The no form of the command deletes the configured
static routes.
ipv6 route <prefix> <prefix len> ([<NextHop>] {[vlan <id]})
[<administrative distance>] [unicast]
no ipv6 route <prefix> <prefix Len> {<NextHop>| {vlan <id>}}
[<administrative distance>] [unicast]
Syntax Description
prefix - IPv6 Prefix of the destination
prefix Len - Destination prefix length
Next-Hop - IPv6 prefix of the next hop that is used to reach the destination network
vlan - VLAN Identifier
administrative distance - Metric to reach the destination
unicast - Unicast type of prefix
Mode
Global Configuration Mode
Defaults
administrative distance – 1 unicast
Example
SMIS(config)# ipv6 route 2111::1111 64 3111::1111
A Route will be configured only when a proper route exists for the next-hop prefix in the route
table.
Related Commands
ipv6 - link local address – Configures the IPv6 link-local address on the interface
show ipv6 route – Displays the IPv6 Routes
To Next Page
Loading...
