Release : 1.1f 720 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.15 bgp nonbgproute-advt
This command controls the advertisement of Non-BGP routes either to the external peer or both
to internal and external peer and the no form of the command resets the Non BGP routes advt
policy to default. By default, the non BGP routes are advertised to internal and external peers.
bgp nonbgproute-advt <external|both>
no bgp nonbgproute-advt
Syntax Description
external - Denotes that the non-BGP routes need to be advertised to external peers
both - Determines that the non-BGP routes need to be advertised to both internal and external
peers
Mode
Router Configuration Mode
Defaults
both
Example
SMIS(config-router)# bgp nonbgproute-advt both
The Administrator can effectively control the advertisement of the route learnt through
Redistribution.
BGP Speaker Local AS number must be configured
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
To Next Page
Loading...
