Supermicro SSE-G48-TG4 - Ip Rip Default Route Originate

Release : 1.1f 634 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
25.12 ip rip default route originate
This command sets the metric to be used for default route propagated over the interface. The no
form of the command disables origination of default route over the interface.
ip rip default route originate <metric(1-15)>
no ip rip default route originate
Mode
Interface Configuration Mode
Defaults
no ip rip default route originate
Example
SMIS(config-if)# ip rip default route originate 10
The RIP must be enabled on the interface.
Related Commands
show ip rip – Displays IP RIP protocol database or statistics
show ip protocols - Displays information about the active routing protocol process