Release : 1.1f 684 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.33 debug ip ospf
This command sets the OSPF debug level. and the no form of the command removes an old
MD5 key.
debug ip ospf { pkt { hp | ddp | lrq | lsu | lsa } | module {
adj_formation | ism | nsm | config | interface } }
no debug ip ospf { pkt { hp | ddp | lrq | lsu | lsa } | module {
adj_formation | ism | nsm | config | interface } | all }
Syntax Description
pkt - Packet High Level Dump debug messages
hp - Hello packet debug messages
ddp - DDP packet debug messages
lrq - Link State Request Packet debug messages
lsu - Link State Update Packet debug messages
lsa Link State Acknowledge Packet debug messages
module - RTM Module debug messages
adj_formation - Adjacency formation debug messages
ism - Interface State Machine debug messages
nsm - Neighbor State Machine debug messages
config - Configuration debug messages
interface - Interface
Mode
Privileged EXEC Mode
Example
SMIS# debug ip ospf pkt hp
The information displayed by the show ip ospf retransmission-list command is useful in
debugging OSPF routing operations.
Related Commands
show ip ospf info – Displays general information about OSPF routing process
show debugging – Displays the state of each debugging option
To Next Page
Loading...
