Supermicro SSE-G48-TG4 - Ipv6 Pim Override-Interval

Release : 1.1f 590 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.18 ipv6 pim override-interval
This command sets the override interval configured for the PIMv6 router interface. The no form of
the command sets the default override interval for the PIMv6 router interface.
ipv6 pim override-interval <interval(0-65535)>
no ipv6 pim override-interval
Mode
Interface Configuration Mode
Defaults
0
Example
iss (config-if)# ipv6 pim override-interval 100
The Override interval is the random amount of time delayed for sending override
messages to avoid synchronization of override messages when multiple downstream
routers share a multi-access link.
Related Command
show ipv6 pim interface – Displays the PIMv6 interfaces of the router