Release : 1.1f 489 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
18.7 arp – ip address
This command adds a static entry in the ARP cache and the no form of the command deletes a
static entry from the ARP cache.
arp <ip address> <hardware address> {Vlan <vlan-id(1-4069)> | Linuxvlan
<interface-name>| Cpu0} [arpa]
no arp <ip address>
Syntax Description
ip address - IP address or IP alias to map to the specified MAC address
hardware address - MAC address to map to the specified IP address or IP alias
Vlan - VLAN ID
Linuxvlan - Interface Name of the Linux VLAN Interface
Cpu0 - Out of Band Management Interface
arpa - Address and Routing Parameter Area domain
Mode
Global Configuration Mode
Example
SMIS(config)# arp 10.203.120.21 00:11:22:33:44:55 Vlan 1
The address resolution protocol (ARP) is a protocol used by the Internet Protocol (IP), specifically
IPv4, to map IP network addresses to the hardware addresses used by a data link protocol. The
term address resolution refers to the process of finding an address of a computer in a network.
Interface must be a router port.
Related Commands
show ip arp – Displays IP ARP table for the given VLAN ID/IP Address of ARP entry/MAC
Address of
ARP entry/IP ARP summary table/ARP configuration information
no switchport - Configures the port as a router port
To Next Page
Loading...
