Supermicro SSE-G48-TG4 - Ip Igmp Query-Interval

Release : 1.1f 501 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
19.5 ip igmp query-interval
This command sets the IGMP query interval for the interface and the no form of the command
sets the query interval to the default value.
ip igmp query-interval <value (1-65535) seconds>
no ip igmp query-interval
Mode
Interface Configuration Mode
Defaults
125
Example
SMIS(config-if)# ip igmp query-interval 30
Related Commands
show ip igmp interface - Displays the interface configuration of IGMP