Supermicro SSE-G48-TG4 - Ipv6 Ospf Neighbor-Probe Interval

Release : 1.1f 869 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.38 ipv6 ospf neighbor-probe interval
This command sets the number of seconds, that indicates how often neighbor will be probed. The
no form of the command sets the default neighbor probe interval.
ipv6 ospf neighbor-probe interval <interval>
no ipv6 ospf neighbor-probe interval
Mode
Interface Configuration Mode
Defaults
interval - 120
Example
SMIS(config-if)# ipv6 ospf neighbor-probe interval 200
Related Command
show ipv6 ospf interface – Displays the OSPFv3-related interface information