Release : 1.1f 583 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.11 ipv6 pim rp-static rp-address
This command sets the address of the IPv6 interface, which will be advertised as a Static-RP.
The no form of the command disables the address of the IPv6 interface, which will be advertised
as a Static-RP.
ipv6 pim rp-static rp-address <Group Address> <Group Mask> <RP address>
no ipv6 pim rp-static rp-address <Group Address> <Group Mask>
Syntax Description
Group Address - Indicates the PIMv6 Sparse multicast group address using the listed RP
Group Mask - IPv6 multicast group address mask that gives the group prefix for which this entry
contains information about RP
RP address - IPv6 address of the Rendezvous Point
Mode
PIM Component Mode
Example
SMIS(pim-comp)# ipv6 pim rp-static rp-address ff02::e001:0000 112
3333::1111
The Static configuration allows additional structuring of the multicast traffic by directing
the multicast join/prune messages to statically configured RPs.
Related Commands
show ipv6 pim rp-static – Displays the RP-static information
To Next Page
Loading...
