Release : 1.1f 737 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.29 bgp comm-policy
This command configures the community attribute advertisement policy for specific destination.
The no form of the command removes the community attribute advertisement policy for specific
destination.
bgp comm-policy <ip-address> <ip_mask> <set-add|set-none|modify>
no bgp comm-policy <ip-address> <ip_mask>
Syntax Description
ip-address - Route prefix on which community policy needs to be applied
ip-mask - Mask associated with the ip address
set-add - Sends only the configured additive communities with associated route
set-none - Sends the associated route without any communities
modify - Removes the associated route with received delete communities and adds the
configured additive communities
Mode
Router Configuration Mode
Example
SMIS(config-router)# bgp comm-policy
BGP Speaker Local AS number must be configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp community – Displays the contents of route/peer/filter/policy community tables
To Next Page
Loading...
