Release : 1.1f 926 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
33.13 deny udp
This command specifies the UDP packets to be rejected based on the associated parameters.
deny udp { any | host <src-ip-address> | <src-ip-address> <src-
mask>}[{gt <port-number (1-65535)> | lt <port-number (1-65535)>| eq
<port-number (1- 65535)> | range <port-number (1-65535)> <port-number
(1-65535)>}]{ any | host <dest-ip-address> | <dest-ip-address> <dest-
mask> }[{ gt <port-number (1- 65535)> | lt <port-number (1-65535)>| eq
<port-number (1-65535)>| range <portnumber (1-65535)> <port-number (1-
65535)>}][{tos{max-reliability|maxthroughput| min-delay|normal|<tos-
value(0-7)>} | dscp <value (0-63)>}] [priority <short (1-255)>]
Syntax Description
udp - User Datagram Protocol
any| host <src-ip-address>| <src-ip-address> <src-mask> - Source IP address
can be 'any' or the word 'host' and the dotted decimal address or number of the network or the
host that the packet is from and the network mask to use with the source address
port-number - Port Number. The input for the source and the destination port-number is
prefixed with one of the following operators.
eq=equal
lt=less than
gt=greater than
range=a range of ports; two different port numbers must be specified
any|host <dest-ip-address> |<dest-ip-address> <dest-mask> - Destination IP
address can be 'any' or the word 'host' and the dotted decimal address or number of the network
or the host that the packet is destined for and the network mask to use with the destination
address
tos - Type of service. Can be max-reliability, max throughput, min-delay, normal or a range of
values from 0 to 7, Differentiated Services Code Point (DSCP) values to match against incoming
packets.
Priority - The priority of the filter used to decide which filter rule is applicable when the packet
matches with more than one filter rules. Higher value of 'filter priority' implies a higher
priority.
Mode
ACL Extended Access List Configuration Mode
To Next Page
Loading...
