Release : 1.1f 842 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.13 area - external summary address
This command enables route aggregation/filtering while importing routes in the OSPFv3 domain.
The command configures Type-5 and Type-7 Address Range specifying whether Type-5/Type-7
LSAs are generated or not for the configured range for the particular area.
area <AreaID> summary-prefix <IPv6-Prefix> <Prefix-Length> [{ allowAll
| denyAll | advertise | not-advertise}] [Translation { enabled |
disabled }]
Syntax Description
AreaID - A 32-bit integer
summary-prefix - Summary Prefix
IPv6-Prefix - The IPv6 address prefix of the range
Prefix-Length - The prefix length of the address range
allowAll - When set to allowAll and the associated areaId is 0.0.0.0, aggregated Type-5 LSAs
are generated for the specified range. In addition, aggregated Type-7 LSAs are generated in all
the attached NSSAs for the specified range.
denyAll - When set to denyAll, neither Type-5 LSA nor Type-7 LSAs are generated for the
specified range.
advertise - When set to advertise, and the associated areaId is 0.0.0.0, aggregated Type-5
LSAs are generated. Otherwise, if the associated areaId is x.x.x.x (other than 0.0.0.0),
aggregated Type-7 LSA is generated in NSSA area x.x.x.x.
not-advertise - When set to doNotAdvertise, and the associated areaId is 0.0.0.0, Type-5
LSA is not generated for the specified range, while all the NSSA LSAs within this range are
flushed out and aggregated Type-7 LSA is generated in all attached NSSAs. If associated areaId
is x.x.x.x (other than 0.0.0.0), Type-7 LSA is not generated in NSSA x.x.x.x for the specified
range.
Translation - When set to enabled, the P-Bit is set in the generated Type-7 LSA. When set to
disabled, the P-Bit is cleared in the generated Type-7 LSA for the range.
Mode
Router Configuration Mode
Defaults
Translation – enabled advertise
To Next Page
Loading...
