Release : 1.1f 735 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.27 bgp comm-peer
This command enables/disables advertisement of community attributes to peer and the no form
of the command disables advertisement of community attributes to peer.
bgp comm-peer <ip-address> <permit|deny>
no bgp comm-peer <ip-address>
Syntax Description
ip-address - Route prefix on which community policy needs to be applied
permit - Allow advertisement of community attributes to peer
deny - Filters advertisement of community attributes to peer
Mode
Router Configuration Mode
Defaults
Deny
Example
SMIS(config-router)# bgp comm-peer 23.45.0.1 deny
BGP Speaker Local AS number must be configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp community – Displays the contents of route/peer/filter/policy community tables
To Next Page
Loading...
