Release : 1.1f 847 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.17 no area
This command deletes an area and does any one of the following based on the optional
parameter. coverts stub/nss area to normal area deletes virtual link deletes stub cost
delete area-range or summary-prefix.
no area <area-id> [ { stub | nssa | virtual-link <router-id> | default-
metric | {range {summary | Type7} | summary-prefix} <IPv6-Prefix>
<Prefix-Length>} ]
Syntax Description
area-id - A 32-bit integer
stub - Stub area
nssa - Not So Stubby Area
virtual-link - The Router ID of the virtual neighbor
default-metric - Cost for the default summary route in a stub/NSS area
range - Type-3 or Type-7 or External LSA range
IPv6-Prefix - The IPv6 address prefix of the range
Prefix-Length - The prefix length of the address range
Mode
Router Configuration Mode
Example
SMIS(config-router)# no area 1.1.1.1
SMIS(config-router)# no area 1.1.1.1 stub
SMIS(config-router)# no area 1.1.1.1 default-metric
SMIS(config-router)# no area 1.1.1.1 virtual-link 20.0.0.3
SMIS(config-router)# no area 1.1.1.1 range summary
3ffe:3010:481d::5 80
Before deleting an area, it is necessary to delete all the interfaces attached to that area.
Related Commands
show ipv6 ospf areas – Displays the Area Table
show ipv6 ospf - area-range / summary-prefix – Displays either the list of all area
address ranges information or all external summary address configuration information
no ipv6 ospf area – Disables OSPFv3 routing protocol on the interface
To Next Page
Loading...
