Release : 1.1f 548 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.14 ip pim query-interval
This command sets the frequency at which PIM hello messages are transmitted on this interface
and the no form of the command sets the default hello timer interval for this interface.
ip pim query-interval <Interval (0-65535)secs>
no ip pim query-interval
Mode
Interface Configuration Mode
Defaults
30
Example
iss (config-if)# ip pim query-interval 60
The query message informs the presence of a PIM router on the interface to the
neighboring PIM routers.
Related Command
show ip pim interface – Displays the routers PIM interfaces
To Next Page
Loading...
