Release : 1.1f 568 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.32 show ip pim thresholds
This command displays threshold configured for SPT, RP thresholds, and rate limit values for
both SM (Sparse mode
show ip pim thresholds
Mode
Privileged EXEC Mode
Example
SMIS# show ip pim thresholds
PIM SPT Threshold Information
Group Threshold: 0
Source Threshold: 0
Switching Period: 0
PIM SPT-RP Threshold Information
Register Threshold: 0
RP Switching Period: 0
Register Stop rate limit: 5
Related Commands
set ip pim threshold – Specifies the SPT group or source threshold when exceeded,
switching to shortest path tree is initiated
set ip pim spt-switchperiod – Specifies the period (in seconds) over which the data rate
is to be monitored for switching to shortest path tree
set ip pim rp-threshold – Specifies the threshold at which the RP initiates switching to
source specific shortest path tree
set ip pim rp-switchperiod – Specifies the period (in seconds) over which RP monitors
register packets for switching to the source specific shortest path tree
set ip pim regstop-ratelimit-period – Specifies the period over which RP monitors
number of register packets after sending the register stop message
set ip pim pmbr – Enables or disables the PMBR (PIM Multicast Border Router) Status
ip pim dr-priority – Sets the designated router priority value configured for the router
interface
To Next Page
Loading...
