Release : 1.1f 868 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.37 ipv6 ospf neighbor-probe retransmit-limit
This command sets the number of consecutive LSA retransmissions before the neighbor is
deemed inactive. The no form of the command sets the default neighbor probe retransmission
limit.
ipv6 ospf neighbor-probe retransmit-limit <retrans-limit>
no ipv6 ospf neighbor-probe retransmit-limit
Mode
Interface Configuration Mode
Defaults
retrans-limit - 10
Example
SMIS(config-if)# ipv6 ospf neighbor-probe retransmit-limit 30
Related Command
show ipv6 ospf interface – Displays the OSPFv3-related interface information
To Next Page
Loading...
