Release : 1.1f 483 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
18.1 show ip information
This command displays IP configuration information.
show ip information
Mode
Privileged EXEC Mode
Example
SMIS# show ip information
Global IP Configuration:
------------------------
IP routing is enabled
Default TTL is 64
IGMP is globally disabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP echo replies are always sent
ICMP mask replies are always sent
Number of aggregate routes is 10
Number of multi-paths is 2
Load sharing is disabled
Path MTU discovery is disabled
Related Commands
ip redirects – Enables sending ICMP
ip unreachables – Enables sending ICMP unreachable message
ip mask-reply – Enables sending ICMP Mask Reply messages
ip echo-reply – Enables sending ICMP Echo Reply messages
maximum-paths – Sets the maximum number of multipaths
ip aggregate-route – Sets the maximum number of aggregate routes
ip path mtu discover – Enables path mtu discovery
traffic-share - Enables traffic sharing
To Next Page
Loading...
