Release : 1.1f 716 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.11 neighbor - interval
This command configures neighbor interval and the no form of the command resets neighbor
interval.
neighbor <ip-address> {advertisement-interval <seconds> | as-
originationinterval <seconds> | connect-retry-interval <seconds>}
no neighbor <ip-address> {advertisement-interval | as-origination-
interval | connect-retry-interval}
Syntax Description
ip-address - Peer ip address
advertisementinterval - The time-interval ( in seconds) for spacing advertisement
of successive external route-updates to the same destination
as-originationinterval - The time-interval (in seconds) for spacing successive
route-updates originating within the same AS
connect-retryinterval - The time interval (in seconds) after which a transport
connection with peer is re-initiated
Mode
Router Configuration Mode
Example
SMIS(config-router)# neighbor 23.45.0.1 advertisement-interval 45
as-origination-interval 30 connect-retry-interval 15
BGP Speaker Local AS number must be configured
Peer must have been created and peer AS must be configured
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
To Next Page
Loading...
